How do you keep your receive short in table tennis?
A short receive is one that would bounce twice on the server's side: its second bounce would land on the table, not past the end line. To keep it short, step in with your playing-side leg so you are close to the ball, meet it soon after it bounces, set the racket angle for the spin, and touch it gently forward rather than swinging. Only receive short against short serves; a half-long or long serve should usually be attacked instead.
Why receive short
A short receive takes away the server's easiest third-ball attack. A long passive push against a short backspin serve is exactly the ball most servers are hoping for. A short, low return forces them to play another short ball or to attempt a risky flick, so the server's advantage shrinks.
Short means length, not stroke type. A push that lands close to the net counts as short; a push that drifts to the end line does not. What decides it is where the ball bounces.
Technique
- Read the length first: the server's first bounce near the net usually means a short serve. Decide early whether it is short.
- Step in with your playing-side leg under the table so the racket reaches the ball comfortably, without stretching your arm.
- Contact early, soon after the bounce, before the ball rises high. Early contact gives the ball less room to travel.
- Set the angle for the spin before the stroke: open the face against backspin, angle it against sidespin.
- Use a short, soft forward touch. The less you swing, the shorter it stays. Keep the wrist quiet and hold the angle through contact.
- Recover back to your ready stance immediately, because the server can still flick or push long.
Common mistakes
The ball pops up: the face was too closed for the backspin, or you just stabbed at it. Open the face and brush slightly forward under the ball. The ball goes half-long: you met it too late or pushed it too hard. Half-long balls are the most punished ball in the game, because the server can loop them easily.
Reaching with a straight arm instead of moving your feet is another frequent cause, especially against sidespin serves. Move first, then touch.
When not to receive short
If the serve is half-long or long, its second bounce would go past the end line, and you should usually attack it with topspin or block it with a set angle rather than try to drop it short. Coaches also warn that dropping a short sidespin serve to the backhand side is hard even for strong players; a flick or a ball pressed along the spin can be a better choice there.
Vary it, too. If every receive is short, the server will wait for it. Mixing short receives with deep, low pushes to different spots keeps them guessing.
How to train it
- Partner serves short backspin; you receive so the ball bounces twice on their side. Put a target close to the net.
- Partner mixes short and half-long serves; call 'short' or 'long' as the ball passes the net, then receive accordingly.
- Receive short, then play the next ball: the server pushes long or flicks, and you continue.
FAQ
Is a short receive the same as a drop shot?
A drop shot is one way to receive short, touching the ball right after the bounce so it dies near the net. A short push also counts as a short receive if its second bounce would stay on the table.
Should beginners try to receive short?
First make the receive land with a safe margin. Once that is consistent, start controlling length and aim short against short serves.
What if the server keeps flicking my short receive?
Keep it lower, vary the placement, and mix in deep pushes so they cannot sit on your short ball.
More guides
- How do I analyze my own table tennis match video?
- How do you film table tennis with a phone for analysis?
- How do I build a practice plan from my match results?
- How do you read the spin on a table tennis serve?
- Table tennis scoring rules: 11 points, deuce, serves
- Where should you serve in table tennis: short or long?
- What are the best 3rd-ball attack patterns after your serve?
- How do I find out why I'm losing points in table tennis?